SECTION C - DESCRIPTION/SPECIFICATIONS/WORK STATEMENT
See Atchs 1 "Statement of Objectives" to be replaced with "Contractor's ITAMP" and Atch 6 entitled "Technical Requirements Document".
SECTION D - PACKAGING AND MARKING
All deliverable contract items shall be packaged in accordance with Contractor's best commercial methods to ensure safe arrival at destination.
SECTION E - INSPECTION AND ACCEPTANCE
1. THE PLACE OF FINAL INSPECTION AND ACCEPTANCE FOR THE CONTRACT WORK CALLED FOR IN SECTION B SHALL BE:
CLIN 0001 By the Integrated Test Force Director at Edwards AFB, CA.
CLIN 0002 IAW the CDRLs attached hereto as Exhibits.
CLIN 0003 By the Government at a location designated by the Contractor or the manufacturing facility.
CLIN 0004 *
CLIN 0005 *
CLIN 0006 IAW Task Order Guidance, Attachment 3.
CLIN 0007 IAW Task Order Guidance, Attachment 3.
CLIN 0008 By the Government at a location designated by the Contractor or the manufacturing facility.
CLIN 0009 *
CLIN 0010 *
CLIN 0011 Reserved.
CLIN 0012 The Applicable Test Range (if exercised).
CLIN 0013 Reserved.
52.246-3 Inspection of Services - Cost Reimbursement (CLIN 0006 & 0007) APR 1984
52.246-8 Inspection of Research and Development - Cost-Reimbursement APR 1984
3. THE FOLLOWING DFARS CLAUSES ARE INCORPORATED HEREIN BY REFERENCE.
252.246-7000 Material Inspection and Receiving Report DEC 1991
The Following Additional Clauses Are Applicable To This Contract:
4. REQUIREMENTS FOR DATA ACCEPTANCE -EXHIBIT.
The Contractor shall prepare and submit a DD Form 250 on an annual basis collectively accounting for all completed Exhibit Line Items which called for submission of data with a letter of transmittal. Each periodic DD Form 250 shall include a list and an account of all data submitted.
5. INSPECTION AND ACCEPTANCE OF NON-COMMERCIAL ITEMS.
a. Notwithstanding the requirement of the FAR clauses incorporated by reference in paragraph 2, above, the Contractor is authorized to use existing industry quality assurance, configuration management, engineering and program management processes, procedures, and
standards as determined acceptable by the Government. The Air Force will be the focal point for waiver requests regarding air worthiness, safety of flight, certification and registration of the ABL weapon system.
b. For aircraft modifications, inspection and certification will employ best commercial practices including FAA certification. The FAA will be the cognizant authority for oversight and acceptance of these aircraft modifications.
6. INSPECTION AND ACCEPTANCE OF COMMERCIAL ITEMS (CLINS 0003-0005 & 0008-0010)
Commercial items, including hardware, data, and services, delivered under this contract shall be inspected and accepted in accordance with FAR 52.212-4 (a), Inspection/Acceptance. Delivery of CLINs 0003-0005 & CLINs 0008-0010 shall be at a location designated by the Contractor and approved by the Government with adequate advance notice to the Government's designated representative. Delivery of the aircraft in CLINs 0003 & 0008 shall be by Commercial Bill of Sale (see Special Provision H-21).